There are six Windows XP Setup boot floppy disks. You must have the files and the drivers that these disks contain to access the CD-ROM drive and to start the Setup process.
Create the Setup disks
When you download the Setup disks, the download contains only one large program file. When you run the downloaded file, it extracts the files. You receive the following prompt:
This program creates the Setup boot disks for Microsoft Windows XP. To create these disks, you need to provide 6 blank, formatted, high-density disks.
Please specify the floppy drive to copy the images to:
Type the drive letter for the floppy disk drive (this is typically drive A). After you type the floppy disk drive letter, you receive the following prompt:
Insert one of these disks into drive drive letter:. This disk will become the Windows XP Setup Boot Disk.
Press any key when you are ready.
When you press a key, the downloaded file starts to extract and copy the files. Continue to insert the blank disks as you are prompted to do so until all six disks are created. If the process is interrupted, you must run the downloaded program file again to create all six disks.
Make sure to label each disk appropriately with the number that is specified by the program. You must use the disks in the correct order during the Setup process.
Download the Setup disk program file
Windows XP original release
For information about the Setup boot disk versions that are available for download, visit the following Microsoft Web sites:
Windows XP Service Pack 1 (SP1)
Note Windows XP CD-ROMs that include SP1 have the text "Includes Service Pack 1" on the CD-ROM.
For information about the Setup boot disk versions that are available for download, visit the following Microsoft Web sites:
Windows XP Service Pack 2 (SP2)
For information about the Setup boot disk versions that are available for download, visit the following Microsoft Web sites: